← MeshCoreNG docs

MeshCoreNG

LoRa mesh repeater firmware — dense-mesh telemetry • internet bridge • power saving
Use Chrome or Edge — Web Serial is not supported in Firefox or Safari.

1 Choose firmware type

2 Select your board

Select a firmware type first.

3 Choose firmware version

Select a board first.

4 Connect & flash

Plug your board into USB, then press the button below.

nRF52, RP2040 and STM32 boards cannot be flashed here. Download the .uf2, .zip or .hex from GitHub Releases.

5 First use

  1. Connect via USB serial at 115 200 baud (e.g. config.meshcore.io).
  2. For bridge firmware: set bridge.enabled on
  3. Check stats: get dense.stats
  4. Use any MeshCore client to connect: app.meshcore.nz

Full documentation: MeshCoreNG docs • GitHub